#Check after effect serial number serial number
#Check after effect serial number verification

#Check after effect serial number serial number

The serial number must be placed in a manner not susceptible of being readily obliterated, altered, or removed, and must not duplicate any serial number placed by you on any other firearm. You, as a licensed manufacturer or licensed importer of firearms, must legibly identify each firearm manufactured or imported as follows:Д«y engraving, casting, stamping (impressing), or otherwise conspicuously placing or causing to be engraved, cast, stamped (impressed) or placed on the frame or receiver thereof an individual serial number. Identification of FirearmsДў7 CFR 478.92 Q: How must licensed manufacturers and licensed importers identify firearms, armor piercing ammunition? The Director, Bureau of Alcohol, Tobacco, Firearms and Explosives may authorize other means of firearms identification upon receipt of a letter application from the importer, submitted in duplicate, showing that such other means of identification is reasonable and will not hinder the effective administration of the regulations. If the manufacturer did not mark them, the importer must place the required markings on the firearm within 15 days after their release from Customs and Border Protection custody. Note: The importer must ensure that these marks of identification appear on each firearm. For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the importerвЂ™s city and state must be to a minimum depth of.For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the importerвЂ™s name must be to a minimum depth of.For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the caliber or gauge must be to a minimum depth of.For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the model designation must be to a minimum depth of.For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the country of origin must be to a minimum depth of.For firearms imported after January 30, 2002, the engraving, casting or stamping (impressing) of the serial number must be to a minimum depth of.Must be conspicuously engraved, cast or stamped (impressed) on the firearm frame, receiver, barrel or slide.003 inch and in a print size no smaller than 1/16 inch

The serial number cannot duplicate the serial number appearing on any other firearm the importer previously imported.

Must be conspicuously engraved, cast or stamped (impressed) on the firearm frame or receiver.

#Check after effect serial number verification

Firearms Verification Firearms Verification Overview Marking Requirements